Grab your darkroom timers at discounts!
User's manual
Kronotron uses the T3231 chip to control the power output. It's easy to set up and use following this steps
This place doesn't exist... Ai website generation is weird!
Program mode
Click set (S) for 5 seconds until P0 appears. Click S again to cycle between P0 and P1. Click R to exit and start program.
P0 is used to select time units. P0-0 for seconds, P0-1 for minutes and P0-2 for hours. There are 6 modes in P1:
P1-0: Off (Blue timer) --> On
P1-1: On (Red timer) --> Off (Single exposure)
P1-2: Off (Blue timer) --> On (Red timer) --> Off (single exposure with delay)
P1-3: On (Red timer) --> Off (Blue timer) --> On
P1-4: Off (blue timer) --> On (red timer)--> Loop (Test strip mode)
P1-5: On (Red timer) --> Off (blue timer) --> Loop (Test strip mode)
Change time mode
Double-click the set button (S) until the numbers flash. Click S again to cycle between red and blue numbers. Red numbers represent the time that power is on and blue is the time that power is off. Use up and down buttons to select time (0-999). Click R to exit and start
Expose mode
Just select the program and the time, and click R to start and re-start. Turn off to terminate, next time you turn it on it will be set in the last used program,